Hazards, and what to do about each one
Fifteen things that turn up in old furniture or in the work on it. Where each one shows up, how to tell, what to do, who to call, and which published source says so.
Everything here is recognition and a stop. This manual does not teach fumigation, lead paint removal, mold remediation or stripping, and the reasons are in the sources themselves: EPA says not to attempt to remove lead-based paint yourself, both extension entomology sources restrict fumigation to licensed operators, and the museum mold guidance is explicit that killing mold does not end the health hazard. What can hurt you in old furniture is the chapter; this is the table.
Filter by the buttons, or type in the box. Every date below is the date the source was read for this manual.
| Hazard | Where it turns up | How to tell | What to do | Who to call | Who says so |
|---|---|---|---|---|---|
| Lyctid powderpost beetle | Hardwoods only: oak, ash, walnut, hickory, poplar, cherry. Starch under about 3 percent stops egg-laying | Round exit holes described as about the size of a pinhead, with no numeric figure given; fine powder | Isolate the piece. Sweep the powder, mark the holes, date it, recheck in spring or summer | Extension entomologist, or a licensed pest control operator | University of Kentucky Entomology, ENTFACT-616, revised March 2026 |
| Anobiid powderpost beetle | Hardwoods and softwoods. Larvae need 13 to 30 percent wood moisture content | Exit holes 1/16 to 1/8 inch | As above. This is the family that can re-infest year after year, so an identification matters more here | As above | University of Kentucky Entomology, ENTFACT-616 |
| Bostrichid beetle | Mainly hardwood, especially newly processed wood with high starch and moisture; tropical hardwoods and bamboo | Circular holes 1/8 to 1/4 inch. Holes made by egg-laying females are free of powder | As above. Said to seldom re-infest after the first generation emerges | As above | University of Kentucky Entomology, ENTFACT-616 |
| Exit hole sizes: a conflict between sources | Any infested wood | Penn State gives "about 1/16 to 1/8 inch" on its page about Lyctidae; Kentucky gives that range for anobiids and describes lyctid holes as pinhead-sized with no figure. The Park Service gives 1/16 to 3/16 inch for wood-boring beetles in upholstered furniture | Measure and record the size; do not name a family from it | The identification is made by someone who can look at the wood, the holes and ideally a beetle | Penn State Extension, updated June 2026; University of Kentucky ENTFACT-616; NPS Conserve O Gram 7/4 |
| Active versus old infestation | Any holes | Powder the color of freshly sawed wood suggests active; yellowed, caked or dusty powder suggests old. Vibration can dislodge old powder, so one look is not the test | Mark the holes, sweep the powder, date it, look again. Emergence is mostly spring or summer, so a winter recheck can be inconclusive | As above, if powder returns | University of Kentucky Entomology, ENTFACT-616 |
| Foreign grain beetle (the lookalike) | Poorly seasoned lumber, wet plaster and wallboard, often in newer buildings | About 1/16 inch, reddish brown, with a small knob at each front corner of the segment behind the head, needing magnification to see | Nothing to the furniture. It feeds on molds and fungi and does not damage wood; remove the moisture source and it goes | Nobody, for the wood. Find the damp | University of Kentucky Entomology, ENTFACT-610 |
| Fabric pests in upholstery | Proteinaceous materials: silk, horsehair, wool. Larvae are repelled by light and feed in dark undisturbed places | Cast skins, debris and grazed fabric in crevices; damage inside rather than on show surfaces | Record it. If the show fabric is unstable, do not vacuum it | A textiles conservator, or a pest control operator | NPS Conserve O Gram 7/4, July 1993 |
| Mold | Anything damp. Cellulose materials including wood, and proteinaceous materials including leather, parchment, adhesives and hair cloth, are particularly susceptible | A musty odor is often the first indication, before anything is visible. Stains, or velvety or powdery growth of almost any color | Keep the piece out of the house. Seal it in polyethylene to stop spores spreading. Do not touch the mold; touching spreads spores. Protective equipment named is a HEPA respirator, goggles, disposable gloves and a washable coat | A conservator, and a doctor if anyone in the house is affected | NPS Conserve O Gram 3/4, August 2007 |
| Mold that looks dead | A piece that was damp and is now dry | No visible growth, but a history of damp | Treat as unresolved. Extreme cold, freezing and heat deactivate spores without killing them, and spores reactivate when it warms. Killing mold does not eliminate all health hazards, and inactive mold may cause reactions in sensitive people | As above. Higher risk is named for people with respiratory problems, severe allergies, diabetes and compromised immune systems | NPS Conserve O Gram 3/4 |
| Bed bugs | Seams and folds of luggage, bags, folded clothes, bedding and furniture. How clean a place is does not determine whether they are present | Shed exoskeletons; rusty blood spots on mattresses or nearby furniture | Inspect the seams, folds and tufting before the piece comes in. Not known to spread disease | A professional pest control company for an infestation | Centers for Disease Control and Prevention |
| Lead-era paint | Painted surfaces that may predate the 1978 federal ban on lead-based paint for homes and childcare facilities | You cannot tell by looking. EPA says CPSC does not recommend home lead test kits for use on consumer products | Do not attempt to remove lead-based paint yourself. For damaged areas under 6 square feet, fix without sanding, and wet the area first if you must sand. Do not use steel wool, scouring pads, or abrasive or solvent cleaners that may dissolve paint | A lead-safe certified firm, which paid work disturbing paint in pre-1978 housing requires | US EPA, updated November 2026 |
| Lead in furniture coatings as regulated | Children's products and certain furniture articles: the examples given include beds, bookcases, chairs, chests, tables and dressers | A legal limit on what may be sold rather than something you can measure at home | Know what it is and is not: the limit is 0.009 percent, which is 90 parts per million, of lead in paint or similar surface coatings, codified at 16 CFR part 1303. It says nothing about a piece made in 1935 and is not a safe level for sanding | Not applicable: this is a sales standard | US Consumer Product Safety Commission |
| Methylene chloride stripper | Consumer paint and coating removers | Read the label | Since 22 November 2019, manufacturing, processing and distributing methylene chloride for consumer paint and coating removal has been prohibited, including distribution to and by retailers and e-commerce. EPA's page on that rule was dated 10 November 2026 and shows no court action | A professional, if stripping is the decision. This manual does not teach it | US EPA, 2019 rule page |
| The 2024 methylene chloride rule | The broader restrictions finalized in April 2024 | Widely reported as in force; it is not | Vacated. EPA's page, dated 13 November 2026, says the Fifth Circuit vacated the 2024 rule in September 2026 in East Fork Enterprises v. EPA, No. 24-60227, that it is no longer in effect, and that the decision did not affect the 2019 rule or OSHA requirements. This is live litigation: check the page yourself | Not applicable | US EPA, risk management page |
| NMP stripper | The common substitute, in paint and adhesive removers | Read the label | Proposed only. EPA's page, last updated 29 January 2026, describes a rule announced in June 2024 and speaks of what it would do if finalized. Proposed terms include a 45 percent concentration limit in consumer glues and adhesives and commercial bans that would include furniture care products. Docket EPA-HQ-OPPT-2020-0744 | Not applicable | US EPA, NMP risk management page |
| Mineral spirits and naphtha | The finish test and the cleaning routine in this manual | Sold as paint thinner; known industrially as Stoddard solvent | Follow the container's safety instructions, read the safety data sheet, and ventilate throughout the work and the drying. Prevent skin and eye contact. Flash point 102 to 110 °F, a Class II combustible liquid. Target organs: eyes, skin, respiratory system, central nervous system, kidneys | Poison control for an exposure; a doctor for symptoms | NIOSH Pocket Guide; NPS Conserve O Gram 7/1 |
| Denatured alcohol and lacquer thinner | Steps 2 and 3 of the finish test | More volatile than mineral spirits | Same precautions, with more attention to ventilation and to flames, heaters and pilot lights. Keep containers closed between uses | As above | NPS Conserve O Gram 7/1 |
| Xylene and toluene | In some waxes and polishes | Read the ingredients | The waxing guidance advises avoiding waxes carrying the stronger solvents, naming xylene and toluene, which it says can damage some finishes and are more of a health hazard. Prefer turpentine and mineral spirits | Not applicable: choose a different product | NPS Conserve O Gram 7/2 |
| Oily rags | Any work with an oil finish | No warning sign: the heat builds inside a crumpled pile | Spread them in a single layer on concrete, out of direct sunlight, with the corners secured, and let them harden before disposal. For a pile already smoking, call 911 and do not disturb it; spreading it out introduces oxygen | The fire service, for a smoking pile | National Park Service, Fire Prevention 52, citing an NFPA estimate of 14,070 fires a year |
| Old upholstery dust | Inside any upholstered piece | Visible when the piece is moved or vacuumed | Historic padding includes grasses, animal hair, feathers, moss, cotton batting and seaweed. Dust is abrasive and is an attractant and food source for insects. Vacuum stable show fabric at low suction, preferably through a nylon mesh screen of about 18 by 18 inches, with a water-filtering or HEPA vacuum. If the fabric is unstable, do not vacuum | A textiles conservator for unstable fabric | NPS Conserve O Gram 7/4 |
| Formaldehyde in composite wood | Hardwood plywood, MDF and particleboard, and finished goods containing them | A TSCA Title VI label on a newer piece | Know what the label means: products have had to be certified compliant with TSCA Title VI or CARB ATCM Phase II by a third-party certifier since June 2018, and labeled as TSCA Title VI compliant since March 2019. The numeric emission limits are in 40 CFR Part 770 rather than on EPA's summary page | Not applicable | US EPA, formaldehyde standards page |
| Flame retardant chemicals in upholstery | Upholstered furniture sold in California since 2015 | A statement on the flammability label saying whether the upholstery materials contain added flame retardant chemicals, with both options printed and a mark beside the one that applies | Read the label where there is one. The components covered are cover fabrics, barrier materials, resilient filling materials and decking materials. The Bureau says it does not regulate the use of flame retardant chemicals and that its flammability standards are performance standards | Not applicable | California Bureau of Household Goods and Services, B&P Code 19094 FAQ and TB117-2013 FAQ, both updated June 2019 |
This table is for recognizing things and knowing who handles them. It is not a treatment guide, and three of its rows carry dates for a reason.
The methylene chloride and NMP rows describe live federal rulemaking and litigation as the EPA pages read on 13 November 2026. Rules change, and a date on this page is not a substitute for reading the agency's own page. The hole-size rows record a genuine disagreement between two extension services rather than a settled figure. And a clear pass means the listed things were looked for, by you, on one day: it is not a clearance.
Where a row says who to call, that is who makes the identification or does the work, and Who to hire for furniture work explains how to approach them.
Every source in the right-hand column was read for this manual on 13 November 2026, and the full entries, with URLs, are in Where the figures come from.